Ten 8 ft pieces of 2 × 2 × ⅛ inch square steel tube weigh about 269 lb with a 10 % allowance: 88 ft at 3.05 lb per foot, cut from five 20 ft bars. The calculator above does this for square and rectangular tube (HSS) from the standard sizes or any depth, width and wall, and counts the bars of 20, 24 or 40 ft you need.
How the calculator works
Choose the tube size, or "Other size" for any dimensions, then the length of one piece, how many, and an allowance for cuts and mistakes. Pick the bar length your supplier stocks. The result is the total weight with the allowance, weight per foot, one piece, the total length, the bars to buy and the section area, with the section drawn to scale.
Rounded corners
Square and rectangular tube is formed from strip and welded, so its corners are rounded. The AISC Manual computes tube weights with an outside corner radius of twice the wall, and so does the calculator: area = outer rounded rectangle − inner rounded rectangle, weight = area × 3.40 lb per square inch per foot. A square-corner formula, 2 × (depth + width − 2 × wall) × wall, runs 3 to 5 % heavy on small tubes. For HSS 4 × 4 × ¼ it gives 12.75 lb per foot against the tabulated 12.21.
| Tube | lb per foot | 20 ft bar |
|---|---|---|
| 2 × 2 × ⅛ | 3.05 | 61 lb |
| 2 × 2 × ¼ | 5.41 | 108 lb |
| 3 × 3 × ⅛ | 4.76 | 95 lb |
| 3 × 3 × ¼ | 8.81 | 176 lb |
| 4 × 4 × 3/16 | 9.42 | 188 lb |
| 4 × 4 × ¼ | 12.21 | 244 lb |
| 6 × 4 × ¼ | 15.62 | 312 lb |
| 6 × 6 × ¼ | 19.02 | 380 lb |
| 8 × 4 × ¼ | 19.02 | 380 lb |
Bars to buy
The length to buy is the total length of the pieces plus the allowance; dividing by the bar length and rounding up gives the bars. That is a minimum: if the pieces do not divide a bar evenly, the offcuts add up. For exact cutting from bars, with the saw kerf and usable offcuts, plan the pieces in the Cut List Calculator.
Nominal wall and design wall
Tube is sold by nominal wall: a ¼ in tube is made from ¼ in strip. ASTM A500 allows the wall to run thinner, so the AISC Manual uses 93 % of the nominal wall for strength and stiffness (the design wall), while weights stay on the nominal wall. The Beam Deflection Calculator uses the design wall when it checks a tube as a beam.
Common mistakes
- Reading tube size as inside dimensions. HSS sizes are outside dimensions.
- Pricing by weight from a square-corner formula, which overstates small tubes by up to 5 %.
- Ordering the exact total length. Saw kerf, squaring cuts and offcuts eat 5 to 10 %.
For round pipe, use the Pipe Weight Calculator; for plate, bar, angle and channel, the Steel Weight Calculator.