Spreading 4 inches of topsoil over a 20 × 10 ft area takes 66.7 cubic feet, or 2.47 cubic yards, once the soil has settled. Loose soil from the truck settles after rain and rolling, so you order more: with 10 % for settling and 5 % for waste it is 77 cubic feet, 2.85 yards, which weighs about 2.85 tons. In bags that is 103 bags of 0.75 ft³. The calculator above works this out for any area, depth, soil and bag size.
How the calculator works
Enter the length and width, or the area, and the finished depth. If a landscaper already gave you a volume or a supplier quoted tons, use the volume or weight mode instead. The result shows the cubic yards to order, the weight, the bags of the size you pick, how far one yard and one bag go, and how many dump truck loads it takes.
Volume and settling
Volume is area × depth: feet × feet × inches ÷ 12 gives cubic feet, and ÷ 27 gives cubic yards. Topsoil is delivered loose and loses volume as it settles, so the calculator adds a settling allowance, 10 % by default. Screened topsoil that arrives fluffy and dry can settle 15 to 20 %; raise the allowance if you plan to roll the ground or if your supplier's soil is very loose. The waste allowance covers what stays on the tarp and an uneven grade.
Weight
Landscape yards sell topsoil by the yard and quarries often by the ton. A cubic yard of loose topsoil weighs about 2,000 lb; damp soil with a lot of clay weighs more. The calculator uses 2,000 lb as a typical value and accepts the density from your supplier's ticket. If you measured soil in the ground, for example the soil you will dig out of a new bed, switch to the in-ground (bank) volume: dug soil swells by about a quarter, so 10 yards in the ground fill about 12.5 yards of truck.
Bags
Bagged topsoil is labelled by volume: 0.75 ft³ (often marked 40 lb) is the most common size, then 1 and 1.5 ft³. One cubic yard is 36 bags of 0.75 ft³. Above one yard, bulk delivery is usually cheaper and much less work.
How deep should topsoil be?
| Job | Typical depth | One cubic yard covers |
|---|---|---|
| Top-dressing an existing lawn | ¼–½ in | 650–1,300 ft² |
| Filling low spots before seeding | 1–2 in | 162–324 ft² |
| New lawn from seed or sod | 4–6 in | 54–81 ft² |
| Flower beds | 6–8 in | 40–54 ft² |
| Vegetable beds, raised beds | 8–12 in | 27–40 ft² |
Coverage figures are for settled soil, without the allowances. Grass roots grow mostly in the top 4 to 6 inches, which is why that depth is the usual target for a new lawn. Raised beds are often filled with a blend of topsoil and compost; figure the total volume here and split it by the proportion you plan to mix.
Common mistakes
- Ordering exactly the measured volume. The soil settles and the bed ends up an inch short; keep the settling allowance.
- Confusing topsoil with fill dirt. Fill dirt is subsoil for raising grade under a slab or behind a wall and has little organic matter; for that job use the Dirt Calculator.
- Counting bags by weight. A 40 lb bag holds about 0.75 ft³ of dry soil; wet soil weighs more but does not cover more.
- Covering soil against the house. Keep finished grade at least 6 in below siding and sloping away from the foundation; the Slope Calculator checks the fall.
Seeding or laying sod on the new soil? The Sod Calculator counts pallets, seed and starter fertilizer. For mulch on top of beds, see the Mulch Calculator.