Dirt Calculator: fill dirt in cubic yards and tons

How it's calculated. Cubic yards = length × width × depth ÷ 27 (feet), plus about 15 % for compaction and 5 % for waste. Tons = cubic yards × about 1.1 tons per yard of loose fill dirt.
30' × 20' × 6" = 300 ft³ → ×1.15 ×1.05 = 362 ft³ = 13.4 yd³ ≈ 14.8 tons: one tandem dump truck
01

How much?

Start from
ftin
ftin
in
02

Material

Subsoil for grading and backfill

1.1 ton/yd³Density

Typical loose value; quarries differ by 10 % or more. Use the number on your supplier's ticket if you have it.

Volume measured
03

Allowances and delivery

%
%
yd³
ton
Material to order
13.42yd³
Fill dirt · 1.1 ton/yd³ · +15 % / +5 %
Weight14.76 ton
Area600 ft²
Volume placed11.11 yd³
Truck loads1 · limited by payload
One cubic yard covers45 ft²
Typical density; replace it with your supplier's if you have it

Density and delivery

Fill dirt · 1.1 ton/yd³ · +15 % / +5 %
DENSITY, TONS PER CUBIC YARDTopsoilFill dirtClay1.1 ton/yd³LOADS: 1 · limited by payloadDELIMETRA · FT-IN
L × W × depth ÷ 27Formula1.1 ton/yd³Density1Truck loads
Your local prices
$
$
$
$

Prices are not pre-filled: aggregate prices and delivery differ by region and quarry.

How we calculate

Volume = length × width × depth, in consistent units: feet × feet × inches ÷ 12 gives cubic feet, ÷ 27 gives cubic yards.

Weight = volume × loose density. Densities of stone, sand and soil are not standardized: they are measured per ASTM C29 and vary by quarry, gradation and moisture. The calculator starts from typical values and lets you enter your supplier's figure.

Compaction allowance adds the loose material needed to reach a compacted depth; waste covers spillage and an uneven subgrade. Neither is added when you start from a weight you already know.

Soil dug from the ground (bank volume) swells when loosened: 10 yd³ in the ground loads as about 12.5 yd³ at 25 % swell. The weight is the same; the truck volume is not.

Truck loads are limited by whichever runs out first, body volume or legal payload.

To order
13.42yd³

Raising a 30 × 20 ft area by 6 inches takes 300 cubic feet, or 11.1 cubic yards, of compacted fill. Loose dirt from the truck loses volume when it is spread and compacted, so you order about 15 % more, plus 5 % for waste: 362 cubic feet, 13.4 cubic yards, which weighs about 14.8 tons. That is one load for a tandem dump truck. The calculator above does this for any area and depth, for fill dirt, topsoil or clay, and for soil measured in the ground or in the truck.

How the calculator works

Enter the length, width and the depth you need to fill, or the area, or a volume or weight you already know. Choose the soil. Set the compaction and waste allowances and the size of the trucks your hauler runs. The result is the cubic yards to order, the weight, the area and the truck loads, each limited by body volume or payload, whichever runs out first.

Volume

Volume is area × depth. With feet and inches: length × width × (depth in inches ÷ 12) gives cubic feet, ÷ 27 gives cubic yards. For a hole or a trench, use the same formula with the hole's length, width and depth. For an area that is deeper at one end, use the average depth: a yard that needs 2 inches at the house and 10 inches at the fence needs 6 inches on average.

Compaction

Fill dirt is placed in lifts of 6 to 8 inches and compacted with a plate compactor or roller. Loose dirt loses roughly 15 to 25 % of its volume in the process, more for clay and wet soil. The calculator starts at 15 % for fill dirt and 10 % for topsoil, which is only lightly firmed. If you will not compact at all, for example when filling a garden bed, lower the allowance; the soil will still settle over time.

Swell: soil in the ground versus in the truck

Soil is denser in the ground than in a pile. When it is dug, it swells: a typical loam swells about 25 %, clay about 35 %. That matters when you are hauling soil away. If you dig a 10 cubic yard hole, the truck has to take about 12.5 yards of loose soil. Switch the volume measured to "In the ground (bank)" for dug soil; the weight stays the same, but the loose volume and the number of trucks grow.

Weight and trucks

Dirt is heavy. Loose fill dirt weighs about 1.1 tons per cubic yard, topsoil about 1 ton and clay 1.15 tons or more when wet. A tandem dump truck has a body of about 14 cubic yards but a payload of about 15 tons, so a full box of wet clay is over its legal weight. The calculator counts loads both ways and uses the larger number. Enter your hauler's truck if it differs.

SoilTypical tons per cubic yard (loose)Swell when dugCompaction allowance
Topsoil1.0025 %10 %
Fill dirt1.1025 %15 %
Clay1.1535 %15 %

These are typical values: there is no standard density for soil, and moisture changes it a lot. Use the weight on your supplier's ticket if you have it.

Where fill dirt goes and where it does not

Fill dirt is subsoil: mostly mineral, with little organic matter, so it compacts and does not rot. It is the right material for raising grade, backfilling a foundation or a trench, and building up a base before a patio. It is not good for growing grass; put 4 to 6 inches of topsoil on top, figured in the Topsoil Calculator. Under concrete slabs and pavers most builders use crushed stone rather than dirt, figured in the Gravel Calculator.

Common mistakes

Questions

How much fill dirt do I need to raise a 30 × 20 area by 6 inches?

300 ft³ compacted, or 11.1 cubic yards. With 15 % for compaction and 5 % waste, order about 13.4 yards of loose fill, roughly 14.8 tons: one tandem dump truck.

How much does a cubic yard of dirt weigh?

About 2,200 lb (1.1 tons) for loose fill dirt, 2,000 lb for topsoil and 2,300 lb or more for clay, more when wet.

How much dirt is in a dump truck?

A tandem dump truck carries about 10 to 14 cubic yards or 15 tons; a tri-axle about 16 to 18 yards. With dirt the weight limit often runs out before the box is full.

How much extra fill dirt should I order for compaction?

Usually 15 to 25 %. Loose fill compacted in 6 to 8 in lifts loses that much volume; clay and wet soil can lose more.

Why does dug-out soil take more room than the hole?

Soil swells when it is loosened: 10 cubic yards in the ground load as about 12.5 yards in the truck at 25 % swell, and clay swells about 35 %.

What is the difference between fill dirt and topsoil?

Fill dirt is subsoil with little organic matter: it compacts well and does not rot, so it goes under slabs, behind walls and into holes. Topsoil is the top organic layer for growing grass and plants.

Related calculators